Looking for a Hardware Engineer to build Lighting Controller.
Budget: $15 – $25 USD
Requirements:
1. Non-Isolated Input power supply: (110-230V ±10%, 50/60Hz)
2. Output power supply: 100-240v AC 50/60Hz
3. Esp32-s3fh4r2 or Suggestions (Carefully read datasheet, make sure we don’t miss anything)
4. RGB, Programming Header compatible with Esp32 JTAG
5. 1x MOSFET (OSG65R200JF) for driving load mainly dimmable LEDs
6. Trailing Edge Dimming as well as leading edge. (User can select)
7. Power Metering IC (BL0937)
8. Over heat/T emperature protection: 95 degrees and above (DS18B20)
9. Overload protection
10. Use components in stock from JLCPB/LCSC where possible
11. Antenna – PCB Trace Antenna
12. General Purpose button on Esp32 Gpio.
1. Non-Isolated Input power supply: (110-230V ±10%, 50/60Hz)
2. Output power supply: 100-240v AC 50/60Hz
3. Esp32-s3fh4r2 or Suggestions (Carefully read datasheet, make sure we don’t miss anything)
4. RGB, Programming Header compatible with Esp32 JTAG
5. 1x MOSFET (OSG65R200JF) for driving load mainly dimmable LEDs
6. Trailing Edge Dimming as well as leading edge. (User can select)
7. Power Metering IC (BL0937)
8. Over heat/T emperature protection: 95 degrees and above (DS18B20)
9. Overload protection
10. Use components in stock from JLCPB/LCSC where possible
11. Antenna – PCB Trace Antenna
12. General Purpose button on Esp32 Gpio.