Help with OpenPNP and OpenPlacer with Smoothie Board Controller

Project Title: Help with OpenPNP and OpenPlacer with Smoothie Board Controller

I am looking for someone to help with configuring the Smoothie Board Controller and some help with OpenPNP for my pick and place.

Skills and Experience Required:
- Experience in configuring Smoothie Board Controller
- Familiarity with OpenPNP and OpenPlacer
- Knowledge of similar technologies

Timeframe:
- The task needs to be completed within a week.

I have an open placer (Kale CNC) pick and place mini machine where the original controller board had a fault and would not switch all actuators.

I have installed a smoothie board V1 instead and now have all the actuators working, I don't have any motion on any of the stepper motors.

I believe it is an issue with the config.txt file or my on_boot.gcode files, I need someone to look over it and fix where neede
I am also trying to setup open PNP to work with it so may need some help with that too.

The firmware installed in the Smoothie board is the CNC version firmware-2021-02-15-PAXIS-5.bin

Please only apply if you are an expert in Smoothie board V1 and open placer with knowledge of configuration and setup thanks.