Develop Firmware for DA14531 Development Pro kit
Budget: $250 – $750 NZD
I need a simple observer created using the DA14531 module.
It needs to scan for a particular device, named dx54321 continuously, and when the device is detected, it should check if it's within a 3-meter range. If it is within range then turn on 3 outputs else the outputs are off.
Outputs needing to be turned on are P0_9, P0_6 and P0_7 which are named LED, Trig1 and Trig2 respectively.
Link to Development Board, SDK and the guides https://www.renesas.com/us/en/products/wireless-connectivity/bluetooth-low-energy/da14531-smartbond-ultra-low-power-bluetooth-51-system-chip
It needs to scan for a particular device, named dx54321 continuously, and when the device is detected, it should check if it's within a 3-meter range. If it is within range then turn on 3 outputs else the outputs are off.
Outputs needing to be turned on are P0_9, P0_6 and P0_7 which are named LED, Trig1 and Trig2 respectively.
Link to Development Board, SDK and the guides https://www.renesas.com/us/en/products/wireless-connectivity/bluetooth-low-energy/da14531-smartbond-ultra-low-power-bluetooth-51-system-chip