Build a control unit for pneumatic control (inflation & deflation)
Budget: $200 – $300 USD
This is a project to a system using Arduino or the like to constantly monitor air pressure in the line and accordingly open solenoid to adjust pressure by inflating and deflating.
You will be responsible of programming the logic only, I will be taking care of the hardware here.
Sensors used:
1. Air pressure sensors
2. Speed sensor
If you are interested in the project, I can send you the design logic to have a look at it.
You will be responsible of programming the logic only, I will be taking care of the hardware here.
Sensors used:
1. Air pressure sensors
2. Speed sensor
If you are interested in the project, I can send you the design logic to have a look at it.