Adapt a PIC project
Budget: $30 – $250 AUD
This project is to adapt an MPLAB project from a PIC32MX795F512 to a PIC32MX675F512. The previous project was completed on the Microchip Ethernet Starter Kit II and is an Ethernet 2 Serial project.
There has been a new pcb built with the 675 but with many of the same components as found on the Starter Kit.
The new board has some pin changes from the Starter Kit. As much as possible has been kept the same.
The new board does have more capabilities than the old Starter Kit. The new capabilities will need to be implemented as a separate project after the basics have been achieved with this project.
A document outlining my general communications policy and another document showing the pin changes will be included in this project.
Please communicate any difficulties you may have with this project.
There has been a new pcb built with the 675 but with many of the same components as found on the Starter Kit.
The new board has some pin changes from the Starter Kit. As much as possible has been kept the same.
The new board does have more capabilities than the old Starter Kit. The new capabilities will need to be implemented as a separate project after the basics have been achieved with this project.
A document outlining my general communications policy and another document showing the pin changes will be included in this project.
Please communicate any difficulties you may have with this project.