Single-Layer PCB Layout
Budget: £10 – £20 GBP
I have a very small board—just three components in total—that I need laid out on a single-layer PCB as quickly as possible. Two of the parts are SMD, one is through-hole, so the footprint mix is straightforward but does require careful placement to keep the traces on one copper layer clean and manufacturable.
Schematic attached with my preferred board outline. All I need back are production-ready Gerber files, the drill file, and the original design file (KiCad, Eagle, Altium or EasyEDA are all fine—use whatever lets you move fastest).
Because the board is so simple, I’m aiming for a same-day or next-day turnaround. As long as the files load without DRC errors and the board meets the outline I’ve supplied, I can release payment immediately. If you can slot this in right away, let’s get it done.
Schematic attached with my preferred board outline. All I need back are production-ready Gerber files, the drill file, and the original design file (KiCad, Eagle, Altium or EasyEDA are all fine—use whatever lets you move fastest).
Because the board is so simple, I’m aiming for a same-day or next-day turnaround. As long as the files load without DRC errors and the board meets the outline I’ve supplied, I can release payment immediately. If you can slot this in right away, let’s get it done.