build me a circuit design in automation studio
Budget: $15 – $25 USD
design and test a simple Intruder Alarm:
• Initial Conditions: Alarm horn (AH), Red Alarm strobe lamp (ASL1), Yellow Entrance 1 lamp (LP1)
and Yellow Entrance 2 lamp (LP2) are all OFF. Entrance 1 photo-eye sensor (PE1) and Entrance 2
photo-eye sensor (PE2) is OPEN when unblocked and only changes to CLOSE if someone blocks
the beam (i.e., when someone enters).
• If someone enters the room at Entrance 1, the Alarm Horn, Alarm strobe lamp, and Entrance 1
the lamp is all enabled and stays ON until the Alarm Reset push button (PB1) is pressed.
• If someone enters the room at Entrance 2, the Alarm Horn, Alarm strobe, and Entrance 2 lamp
are all enabled and stay ON until the Alarm Reset push button (PB1) is pressed.
• NOTE: For the Alarm strobe light, use a relay oscillator
o PB1 (Alarm Reset) is a momentary, normally open, push button
o Entrance 1 and Entrance 2 Photo-eye sensors are normally open sensors
o Use 24Vdc power supply and 24Vdc relays, alarm horn, and lamps in your circuit
• Initial Conditions: Alarm horn (AH), Red Alarm strobe lamp (ASL1), Yellow Entrance 1 lamp (LP1)
and Yellow Entrance 2 lamp (LP2) are all OFF. Entrance 1 photo-eye sensor (PE1) and Entrance 2
photo-eye sensor (PE2) is OPEN when unblocked and only changes to CLOSE if someone blocks
the beam (i.e., when someone enters).
• If someone enters the room at Entrance 1, the Alarm Horn, Alarm strobe lamp, and Entrance 1
the lamp is all enabled and stays ON until the Alarm Reset push button (PB1) is pressed.
• If someone enters the room at Entrance 2, the Alarm Horn, Alarm strobe, and Entrance 2 lamp
are all enabled and stay ON until the Alarm Reset push button (PB1) is pressed.
• NOTE: For the Alarm strobe light, use a relay oscillator
o PB1 (Alarm Reset) is a momentary, normally open, push button
o Entrance 1 and Entrance 2 Photo-eye sensors are normally open sensors
o Use 24Vdc power supply and 24Vdc relays, alarm horn, and lamps in your circuit