Low-Voltage ETAP Modelling Expert Needed -- 2

**ETAP Support Required for Low-Voltage Short-Circuit and Load Flow Modelling**

I am looking for an experienced ETAP engineer to provide support with the modelling and analysis of a low-voltage electrical network.

The main scope of work includes:

* Modelling single-phase loads connected between phase and neutral;
* Performing short-circuit calculations at the terminals of single-phase consumers;
* Determining phase-to-neutral and phase-to-ground fault currents;
* Correctly modelling the neutral conductor and the grounding/earthing system;
* Verifying the current return paths for phase-to-neutral and phase-to-ground faults;
* Modelling single-phase loads for load flow calculations;
* Reviewing the required ETAP settings, equipment data and calculation parameters;
* Checking whether the obtained results are technically correct and consistent with the applicable IEC calculation methods.

The support should be provided through an online screen-sharing session, during which we will review and configure the ETAP model together.

The ideal freelancer should have practical experience with:

* ETAP short-circuit analysis;
* ETAP load flow analysis;
* Low-voltage three-phase, four-wire systems;
* Single-phase load modelling;
* Neutral and protective-earth conductor modelling;
* IEC 60909 short-circuit calculations.

Please describe your previous experience with similar ETAP models and confirm which ETAP version you normally use.