Fix My VTOL Pre-Arm Error - Need excellent internet speed for screenshare
Budget: $8 – $15 USD
My VTOL build is stuck on the ground: I can't get the settings for my Radiomaster to save and retain settings over reboots. Many consecutive attempts to make the arming switch work have failed, after getting it to work before with a simple SA up down switch. I need a two stage switch utilizing the standard thr <98 logic and the two position SE and SA switch.
I need someone who has a strong internet connection for screensharing who can use team viewer if needed.
• review the existing YAML file for obvious conflicts or missing fields that would block arming using screenshare.
• guide me through any radio calibration or RC-map corrections necessary to satisfy the safety checks
• suggest and, if needed, test-fly (in SITL) revised parameters so the aircraft arms cleanly and lifts off under STABILIZE and QLOITER
Success for me is simple: the pre-arm warning disappears and the drone arms and takes off reliably in bench tests or in a simulator, with clear documentation of what you changed and why. If you prefer using tools like mavproxy, SITL, or QGroundControl instead of Mission Planner, that works for me as long as the end result is a tidy YAML or .param file I can flash straight onto the Cube.
One of the drones was flying last year but the hover test didn't go well and it set me back from october until now.
I need someone who has a strong internet connection for screensharing who can use team viewer if needed.
• review the existing YAML file for obvious conflicts or missing fields that would block arming using screenshare.
• guide me through any radio calibration or RC-map corrections necessary to satisfy the safety checks
• suggest and, if needed, test-fly (in SITL) revised parameters so the aircraft arms cleanly and lifts off under STABILIZE and QLOITER
Success for me is simple: the pre-arm warning disappears and the drone arms and takes off reliably in bench tests or in a simulator, with clear documentation of what you changed and why. If you prefer using tools like mavproxy, SITL, or QGroundControl instead of Mission Planner, that works for me as long as the end result is a tidy YAML or .param file I can flash straight onto the Cube.
One of the drones was flying last year but the hover test didn't go well and it set me back from october until now.