Firmware for Electrotherapy Device
Budget: $20,000 – $30,000 USD
Electro Cellular Healthcare Solutions is looking for a firmware engineer to complete the firmware for our electrotherapy device for two upcoming human clinical studies.
The candidate needs to have direct experience with a St-micro MX + Cube Ide and the microcontroller M4 cortex used like the STM32G491RE or STM32G474RE. The primary task is to create a driver for the Spi 3 of the Nucleo-G491RE development board. The candidate would need to complete the Firmware as per the SOW using Nucleo-G491RE development board. The implementation must be executed using St-micro MX + Cube Ide. The driver needs to support the current hardware VGA QPB0066 programming and the SD card functionality. The current code already has the SD functionality supported but the VGA functionally is not operational. The Firmware needs to support the current hardware as per the SOW. All the code is expected to be fully unit tested for all the allowable cases by the party responsible for the firmware. Power Reading (FWD/REV) and Fan (Servo on CPU Temp) must be completed, as well.
All firmware must be debugged and finalized.
Following an executed NDA, we will provide: 1. Nucleo g491re development board, 2. SPi programmable VGA fixture, 3. A sample of the Signal generator box after code is at satisfactory completion, 4. Current source code, and 5. schematic digital board.
We need this work done as soon as possible and will compensate accordingly to get it done promptly.
The candidate needs to have direct experience with a St-micro MX + Cube Ide and the microcontroller M4 cortex used like the STM32G491RE or STM32G474RE. The primary task is to create a driver for the Spi 3 of the Nucleo-G491RE development board. The candidate would need to complete the Firmware as per the SOW using Nucleo-G491RE development board. The implementation must be executed using St-micro MX + Cube Ide. The driver needs to support the current hardware VGA QPB0066 programming and the SD card functionality. The current code already has the SD functionality supported but the VGA functionally is not operational. The Firmware needs to support the current hardware as per the SOW. All the code is expected to be fully unit tested for all the allowable cases by the party responsible for the firmware. Power Reading (FWD/REV) and Fan (Servo on CPU Temp) must be completed, as well.
All firmware must be debugged and finalized.
Following an executed NDA, we will provide: 1. Nucleo g491re development board, 2. SPi programmable VGA fixture, 3. A sample of the Signal generator box after code is at satisfactory completion, 4. Current source code, and 5. schematic digital board.
We need this work done as soon as possible and will compensate accordingly to get it done promptly.