Finish configuring my Heewing T2 VTOL build - screenshare bandwidth needed -- 3
Budget: $8 – $15 USD
My Heewing T2 VTOL build is stuck on the ground: I'm using the Cube Orange Plus FC. The configuration has been 98% completed with meticulous attention to configuration instructions and research. The primary remaining problem is that I can't get the Nomad backpack to successfully communicate with the receiver (dbr4). The receiver is bound and connected but zero packet transfer.
I need someone with extensive experience with Mission Planner/Ardupilot programming and experience with gemini crossband. Need to configure the crossband connection (all configs according to docs), perform hover and subsequent tuning from hover testing and 1st test flight until issues resolved. Also need to perform pre-flight checks to ensure that all flight systems are working/peripherals like video and gimball are functioning properly.
- Freelancer needs to have strong internet connection with willingness to work via screenshare if needed. I would prefer to observe while you make configurations on my laptop so that you aren't slowed down by me and communications back and forth.
Success for me is simple: The drone flies, safely and flawlessly!!
I need someone with extensive experience with Mission Planner/Ardupilot programming and experience with gemini crossband. Need to configure the crossband connection (all configs according to docs), perform hover and subsequent tuning from hover testing and 1st test flight until issues resolved. Also need to perform pre-flight checks to ensure that all flight systems are working/peripherals like video and gimball are functioning properly.
- Freelancer needs to have strong internet connection with willingness to work via screenshare if needed. I would prefer to observe while you make configurations on my laptop so that you aren't slowed down by me and communications back and forth.
Success for me is simple: The drone flies, safely and flawlessly!!