Create a Design

I need an electric schematic on eagle cad. using a Arduino Uno, GARMIN lidar sensor v3, and MPU-6050 Module.
I would need by December 6 7pm eastern time. the pins are as follow
Connections:
LIDAR-Lite 5 Vdc (red) to Arduino 5v
LIDAR-Lite Ground (black) to Arduino GND
LIDAR-Lite Mode control (yellow) to Arduino digital input (pin 3)
LIDAR-Lite Mode control (yellow) to 1 kOhm resistor lead 1
1 kOhm resistor lead 2 to Arduino digital output (pin 2)
Power Enable (orange) to pin 8 of Arduino

(Capacitor recommended to mitigate inrush current when device is enabled)
680uF capacitor (+) to Arduino 5v
680uF capacitor (-) to Arduino GND

See the Operation Manual for wiring diagrams and more information:
http://static.garmin.com/pumac/LIDAR_Lite_v3_Operation_Manual_and_Technical_Specifications.pdf

These are the connections for the buzzer,acceleromior, button

Buzzer:
(+) to digital pin 12
(-) to Ground

acceleromitor:
Vcc to 5V
GND to GND
SDA and SCL to SDA an SCL of arduino

button:
pin 7
GND

Vibration Motor:
positive end to the 5V power source
negative end to the mosfet
mosfet middle lead to digital pin 5 of the arduino
mosfet third lead to GND