Crestron Program New shade motor to replace old one and Program new Yale lock replacing old one
Budget: $15 – $25 USD
I have just added a new shade motor and a new Yale lock to replace old ones that stopped working and need them fully programmed into my existing Crestron system. Both devices should appear in the control interface exactly the way the rest of my automation does.
Here is the environment you will be working with:
• Crestron CP3 processor
• Hard-wired Cresnet for the shade motor and a direct-to-processor lock gateway for the Yale unit
Program Crestron so that I am able to use the shade from my mobile ap, from remote control and touchpads.
Acceptance will be based on:
• Commands executing without error in Toolbox and from the touch panel
• Feedback matching the physical state of both devices every time
• Source code delivered, clearly commented where you made changes
If you have recent experience integrating shade motors and Yale locks with Crestron, this should be straightforward. Let me know your turnaround time and any clarifications you need.
Here is the environment you will be working with:
• Crestron CP3 processor
• Hard-wired Cresnet for the shade motor and a direct-to-processor lock gateway for the Yale unit
Program Crestron so that I am able to use the shade from my mobile ap, from remote control and touchpads.
Acceptance will be based on:
• Commands executing without error in Toolbox and from the touch panel
• Feedback matching the physical state of both devices every time
• Source code delivered, clearly commented where you made changes
If you have recent experience integrating shade motors and Yale locks with Crestron, this should be straightforward. Let me know your turnaround time and any clarifications you need.