Build-Test 100 mm Aluminum Turbine
Budget: $30 – $250 USD
I need a working 100 mm-diameter turbine, machined from aluminium with stainless or mild-steel blades, closely resembling the reference model shown in my photos. I am not looking for drawings or simulations—I want the physical unit in hand, assembled and proof-tested.
Primary purpose is experimental testing, so please rig the device for safe coupling to a dynamometer or load cell and run it first on steam, then on compressed air and finally on a water jet to compare behavior across the three media.
Provide clear photos and short video clips of each test run, plus a brief table of observed RPM, torque and inlet pressure/flow so I can replicate the setup later.
Deliverables
• Fully assembled 100 mm aluminium turbine with steel blades, ready for additional lab runs
• Video and photo evidence of tests on steam, compressed air and water
• One-page performance summary with your instrumentation notes and readings
Primary purpose is experimental testing, so please rig the device for safe coupling to a dynamometer or load cell and run it first on steam, then on compressed air and finally on a water jet to compare behavior across the three media.
Provide clear photos and short video clips of each test run, plus a brief table of observed RPM, torque and inlet pressure/flow so I can replicate the setup later.
Deliverables
• Fully assembled 100 mm aluminium turbine with steel blades, ready for additional lab runs
• Video and photo evidence of tests on steam, compressed air and water
• One-page performance summary with your instrumentation notes and readings