ESP32 PCB Optimization & Revision
Budget: $30 – $250 USD
I already have a fully routed EasyEDA project built around an ESP32 running MicroPython. The first prototypes work, but the rest of the circuitry is over-engineered. I now want a fresh set of eyes to review and streamline every component except the ESP32 itself.
The targets are clear: trim the bill of materials for lower cost, cut idle and peak current for better power efficiency, and, wherever possible, boost overall performance while reducing wiring complexity. That means analyzing every resistor, capacitor, connector, regulator, sensor and support IC on the board, justifying each part’s value, and proposing smarter substitutes or eliminations.
After the review, I’ll need an updated schematic, a clean BOM, and a revised PCB layout ready for manufacturing export (Gerber, Pick-and-Place, PDF and 3D files). Please keep the design inside EasyEDA so I can continue maintaining it, and annotate your changes with comments for traceability.
If you have a proven track record of squeezing more out of ESP32 boards and you are comfortable iterating directly in EasyEDA, let’s talk timelines and the best way to hand over the current project files.
The targets are clear: trim the bill of materials for lower cost, cut idle and peak current for better power efficiency, and, wherever possible, boost overall performance while reducing wiring complexity. That means analyzing every resistor, capacitor, connector, regulator, sensor and support IC on the board, justifying each part’s value, and proposing smarter substitutes or eliminations.
After the review, I’ll need an updated schematic, a clean BOM, and a revised PCB layout ready for manufacturing export (Gerber, Pick-and-Place, PDF and 3D files). Please keep the design inside EasyEDA so I can continue maintaining it, and annotate your changes with comments for traceability.
If you have a proven track record of squeezing more out of ESP32 boards and you are comfortable iterating directly in EasyEDA, let’s talk timelines and the best way to hand over the current project files.