Digital Circuit Prototyping on Breadboard
Budget: £10 – £15 GBP
I am seeking an expert in digital circuits to assist with the breadboarding of a new design. The project primarily involves working with a USB light.
The light will be made on a copper strip board
It needs the following components:
1. Diode: (e.g., 1N4007) for reverse polarity protection.
2. Capacitor: For power smoothing, typically 100uF.
3. Resistors: One as a current-limiting resistor for the LED, the other for controlling voltage (optional).
4. Push-to-Make Switch: To control the LED.
5. LED: The light-emitting diode.
6. Power Supply: USB 5V.
The board will have the following shape (as attached)
The light will be made on a copper strip board
It needs the following components:
1. Diode: (e.g., 1N4007) for reverse polarity protection.
2. Capacitor: For power smoothing, typically 100uF.
3. Resistors: One as a current-limiting resistor for the LED, the other for controlling voltage (optional).
4. Push-to-Make Switch: To control the LED.
5. LED: The light-emitting diode.
6. Power Supply: USB 5V.
The board will have the following shape (as attached)