Produce a technical drawing to be used in the manufacture of a washing machine enclosure
Budget: £10 – £15 GBP
I am looking for somebody to produce for me a technical drawing, which would be used in the construction of a wooden washing machine enclosure, which would then be lined with some soundproofing foam material.
The washing machine as per the manufacturer's technical specifications measures 60 cm wide by 85 cm high by 63 cm deep (including the porthole) however the enclosure would need to be around 10 cm larger in terms of these measurements (making it 70 cm wide by 95 cm high by 73 cm deep) so as to accommodate the foam. This foam, which is 32 mm thick, would be stuck on using some spray adhesive. There would need to be two holes in the back at either side for the pipes to run through.
The enclosure would need five sides in total (left and right, top as well as a front door and back) although nothing on the bottom. It would be constructed most likely using 18 mm MDF/OSB/plywood-type material.
The washing machine as per the manufacturer's technical specifications measures 60 cm wide by 85 cm high by 63 cm deep (including the porthole) however the enclosure would need to be around 10 cm larger in terms of these measurements (making it 70 cm wide by 95 cm high by 73 cm deep) so as to accommodate the foam. This foam, which is 32 mm thick, would be stuck on using some spray adhesive. There would need to be two holes in the back at either side for the pipes to run through.
The enclosure would need five sides in total (left and right, top as well as a front door and back) although nothing on the bottom. It would be constructed most likely using 18 mm MDF/OSB/plywood-type material.