waveform oscilloscope (two channels) issue using ch32v307 project
Budget: $10 – $30 USD
Hi,
Basically, my project boils down to solving the issue below (which in a way I already solved, that is, the test2.elf is already generated, but with malfunctions)
https://github.com/RT-Thread/rt-thread/issues/6871
https://github.com/neuberfran/test2
When the project is working Ok, I will have 2 sinusoids (one in each channel of my HANMATEK DOS1102) working as shown in the attached figure.
Note: 1) As seen in the figure, the following parameters are used: 1V DC, TIME=0.2ms, FREQUENCY=1000.00Hz
2) I stay using IDE MounRiver Studio and/or MounRiver Studio_Community
Basically, my project boils down to solving the issue below (which in a way I already solved, that is, the test2.elf is already generated, but with malfunctions)
https://github.com/RT-Thread/rt-thread/issues/6871
https://github.com/neuberfran/test2
When the project is working Ok, I will have 2 sinusoids (one in each channel of my HANMATEK DOS1102) working as shown in the attached figure.
Note: 1) As seen in the figure, the following parameters are used: 1V DC, TIME=0.2ms, FREQUENCY=1000.00Hz
2) I stay using IDE MounRiver Studio and/or MounRiver Studio_Community