STM32 getting more debug information after a HardFault in
Budget: $30 – $250 USD
Hi Freelancers,
I try to get much more debug information when entering an HardFault_Handler ..
I followed these steps :
https://blog.vertile.com/article/stm32-hardfault-debugging/
But are still not able to call the hard_fault_handler_c function to get the register contents i need.
Are there STM32 developers out here who can me help with setting up a more detailed debugging system to determine the reason why HardFault_Handler() was triggered?
All i want is status and stack registers to be stored directly after a HardFault.
My controller: STM32G473CCT (32-bit Arm® Cortex®-M4 core )
My debugger : ST-LINK/V2
My IDE : STM32CubeIDE 1.9.0
I preferably want a anydesk or teamviewer sessions where you do the changes while i'm watching. In that case you have access to my debugger and hardware to test if it work.
Thank you
I try to get much more debug information when entering an HardFault_Handler ..
I followed these steps :
https://blog.vertile.com/article/stm32-hardfault-debugging/
But are still not able to call the hard_fault_handler_c function to get the register contents i need.
Are there STM32 developers out here who can me help with setting up a more detailed debugging system to determine the reason why HardFault_Handler() was triggered?
All i want is status and stack registers to be stored directly after a HardFault.
My controller: STM32G473CCT (32-bit Arm® Cortex®-M4 core )
My debugger : ST-LINK/V2
My IDE : STM32CubeIDE 1.9.0
I preferably want a anydesk or teamviewer sessions where you do the changes while i'm watching. In that case you have access to my debugger and hardware to test if it work.
Thank you