Penteste C Pen
Budget: $10 – $30 USD
When switch is ON, 8 LEDs will run slowly.
Design:
All 8 LEDs will be the same which you used or (or better than the used one).
SecOps Logo Light: It will blink from the back-side. Printing Logo on transparent board.
BlackHat Logo Light: It will blink from the back-side. Printing Logo on transparent board.
LED Light will be large as shown, or similar to that one. If not visible, we can use 2+2, lights.
Programming:
K1 - All 8 round lights slow / fast mode / blink mode --- one by one on press.
K2 - After pressing K2, CTF / Programming mode enable --- It will stop all 8 round lights, so that all can guess that Programming mode is activated.
K3 and K4 switch will work after PRESSING K2 and entering code will be allowed thereafter.
If pressed K2 again, it will break all sequence and clean the logs, terminate the programming mode and Blink all 8 lights as per previous preference.
K3 and K4 will work after pressing K2 only.
K3 - 0
K4 - 1
Whenever, K3 and K4 is presseed, One by one each lights will blink. L1, L2, L3, L4, L5, L6, L7, L8.
When pressed:
11101110 -- If the sequence is this, S - SecOps logo Light should blink continuously.
01010111 -- if the sequence is this, Cap - Black Hat and S - SecOps Logos Light Should blink continuously. -- In short all 4 logo lights should blink.
Design:
All 8 LEDs will be the same which you used or (or better than the used one).
SecOps Logo Light: It will blink from the back-side. Printing Logo on transparent board.
BlackHat Logo Light: It will blink from the back-side. Printing Logo on transparent board.
LED Light will be large as shown, or similar to that one. If not visible, we can use 2+2, lights.
Programming:
K1 - All 8 round lights slow / fast mode / blink mode --- one by one on press.
K2 - After pressing K2, CTF / Programming mode enable --- It will stop all 8 round lights, so that all can guess that Programming mode is activated.
K3 and K4 switch will work after PRESSING K2 and entering code will be allowed thereafter.
If pressed K2 again, it will break all sequence and clean the logs, terminate the programming mode and Blink all 8 lights as per previous preference.
K3 and K4 will work after pressing K2 only.
K3 - 0
K4 - 1
Whenever, K3 and K4 is presseed, One by one each lights will blink. L1, L2, L3, L4, L5, L6, L7, L8.
When pressed:
11101110 -- If the sequence is this, S - SecOps logo Light should blink continuously.
01010111 -- if the sequence is this, Cap - Black Hat and S - SecOps Logos Light Should blink continuously. -- In short all 4 logo lights should blink.