ESP32-C3/S3 Interfacing -- 2
Budget: ₹600 – ₹25,000 INR
Hello,I am looking for a experienced coding guy to integrate the following sensors with the ESP32-C3/S3 chipset.(Software only, no hardware design)
Sensors:
1) Touch Display
2)GNSS Module
3) Microphone
4) Keypad
5) Volume knob
6) Analogue Audio interface( audio jack)
Software Requirement:
1) Wifi and Bluetooth enabling/pairing
2) Should connect with Bluetooth devices like speaker/Headphones
3) Ethernet connection via 10/100 M port
4) Audio processing to filter unnecessary noise from Microphone
5) IPv4 / IPv6 based routing for minimum 9 nodes (communication between atleast 9 C3/S3 boards via ethernet/wifi).Important one- will tell in detail via chat.
6) Getting the chip into low power consumption mode.
Note:
The ESP32-S3/C3 will be interfaced to an FPGA via SDIO interface. So,the software should be easy to read and use. So,that the FPGA guy can interface the chipset with less trouble.
Library for the GNSS/other modules may not be available.The freelancer should take care of them. Datasheet and other technical details will be provided.
More details will be given via chat. Circuit design etc..
Please note that all these can't be achieved via Arduino. So,I am looking for someone with experience in ESP-IDF/ VS-code based development environment to harness the full potential of the chipset.
Eligibility:
1)Only experienced guys are requested to apply.
2)The developer should co-operate with team.
Sensors:
1) Touch Display
2)GNSS Module
3) Microphone
4) Keypad
5) Volume knob
6) Analogue Audio interface( audio jack)
Software Requirement:
1) Wifi and Bluetooth enabling/pairing
2) Should connect with Bluetooth devices like speaker/Headphones
3) Ethernet connection via 10/100 M port
4) Audio processing to filter unnecessary noise from Microphone
5) IPv4 / IPv6 based routing for minimum 9 nodes (communication between atleast 9 C3/S3 boards via ethernet/wifi).Important one- will tell in detail via chat.
6) Getting the chip into low power consumption mode.
Note:
The ESP32-S3/C3 will be interfaced to an FPGA via SDIO interface. So,the software should be easy to read and use. So,that the FPGA guy can interface the chipset with less trouble.
Library for the GNSS/other modules may not be available.The freelancer should take care of them. Datasheet and other technical details will be provided.
More details will be given via chat. Circuit design etc..
Please note that all these can't be achieved via Arduino. So,I am looking for someone with experience in ESP-IDF/ VS-code based development environment to harness the full potential of the chipset.
Eligibility:
1)Only experienced guys are requested to apply.
2)The developer should co-operate with team.