I need to create a simple revit model for a model pasta bridge
Budget: $30 – $250 AUD
I need a clean model that matches the built pasta bridge, with levels, grids, and members with correct properties, views and sheets set up correctly.
Model specification
A 3D model of the bridge is to be produced using Autodesk Revit. This model will be used to produce a single A3 drawing. The drawing shall contain sufficient information so that somebody else could build your bridge having only this drawing.
As a guide, this drawing should show the following:
· 1 x plan view
· 1 x section view through the centre of the bridge
· 1 x connection detail
· 1 x side elevation
· All relevant dimensions are shown
· Materials used
· Have a title block with all relevant information shown
Items to submit:
· 1 x A3 drawing as per the above specification in PDF format
· 1 x Revit file (.rvt)
Every member is 4 individual pieces of tubular spaghetti glued together in a square formation
An 8 kg load was applied to a joint as shown in the picture
Model specification
A 3D model of the bridge is to be produced using Autodesk Revit. This model will be used to produce a single A3 drawing. The drawing shall contain sufficient information so that somebody else could build your bridge having only this drawing.
As a guide, this drawing should show the following:
· 1 x plan view
· 1 x section view through the centre of the bridge
· 1 x connection detail
· 1 x side elevation
· All relevant dimensions are shown
· Materials used
· Have a title block with all relevant information shown
Items to submit:
· 1 x A3 drawing as per the above specification in PDF format
· 1 x Revit file (.rvt)
Every member is 4 individual pieces of tubular spaghetti glued together in a square formation
An 8 kg load was applied to a joint as shown in the picture