Contour Profile Editing in AutoCAD
Budget: ₹1,500 – ₹12,500 INR
We have a file consisting of 147 Contour lines, These contour lines need to be edited in a particular fashion to make them smooth in two directions. There are a series of 8 steps to carried out for each Profile line. The steps are :
Step 1: Remove Segmented lines on North and East
Step 2: Scale Balance Lines by Factor 0.95 (Make sure that the grey origin marker is used to scale )
Step 3: Convert Remaining Segmented lines into p-lines
Step 4: Smoothen the Pline by using the "Fit" Command
Step 5: Remove Points that are very close within approximate tolerance of 0.015m
Step 6: Explode the p-line so that it becomes a series of ARCs
Step 7: Join the ends with a Red p-line
Step 8: Converts to closed Loop p-lines
Kindly see the attached video link in which these 8 steps are carried out for a sample Profile.
https://youtu.be/tzXy4mSrZAE
This procedure needs to be done to 147 profiles individually
it will be best if this task is taken up by a team rather than a single freelancer as time is an essence and will like the work to be completed within a day.
Step 1: Remove Segmented lines on North and East
Step 2: Scale Balance Lines by Factor 0.95 (Make sure that the grey origin marker is used to scale )
Step 3: Convert Remaining Segmented lines into p-lines
Step 4: Smoothen the Pline by using the "Fit" Command
Step 5: Remove Points that are very close within approximate tolerance of 0.015m
Step 6: Explode the p-line so that it becomes a series of ARCs
Step 7: Join the ends with a Red p-line
Step 8: Converts to closed Loop p-lines
Kindly see the attached video link in which these 8 steps are carried out for a sample Profile.
https://youtu.be/tzXy4mSrZAE
This procedure needs to be done to 147 profiles individually
it will be best if this task is taken up by a team rather than a single freelancer as time is an essence and will like the work to be completed within a day.