Set up Tasmota Device Groups
Budget: $30 – $250 USD
I am looking for a freelancer to help me set up Tasmota device groups.
Requirements:
- Experience with setting up Tasmota Device Groups or the willingness to learn.
I am looking for a freelancer to help me set up a smart switch with the Tasmota firmware. I am already familiar with the associated hardware and understand how to physically install the switch, but need help with the configuration of Tasmota. I have several Martin Jerry dimmers (SD01) flashed with Tasmota. I also have a Shelly RGBW2 4 channel dimmer that is flashed with Tasmota.
I would like to configure the Martin Jerry dimmers so that each dimmer controls a separate channel on the Shelly RGBW2. I want on/off and dimming functionality, as well the ability to have more than one Martin Jerry dimmer be in control of one of the channels on the RGBW2 device in the event that I need two or more control points. The Martin Jerry dimmers need only to control the Shelly RGBW2 dimmer. There is no need for each dimmer to control their local dimming circuit.
I would like to implement this using Device Groups because DevGroups use UDP to communicate, thereby reducing latency significantly.
Requirements:
- Experience with setting up Tasmota Device Groups or the willingness to learn.
I am looking for a freelancer to help me set up a smart switch with the Tasmota firmware. I am already familiar with the associated hardware and understand how to physically install the switch, but need help with the configuration of Tasmota. I have several Martin Jerry dimmers (SD01) flashed with Tasmota. I also have a Shelly RGBW2 4 channel dimmer that is flashed with Tasmota.
I would like to configure the Martin Jerry dimmers so that each dimmer controls a separate channel on the Shelly RGBW2. I want on/off and dimming functionality, as well the ability to have more than one Martin Jerry dimmer be in control of one of the channels on the RGBW2 device in the event that I need two or more control points. The Martin Jerry dimmers need only to control the Shelly RGBW2 dimmer. There is no need for each dimmer to control their local dimming circuit.
I would like to implement this using Device Groups because DevGroups use UDP to communicate, thereby reducing latency significantly.