Heater system
Budget: $250 – $750 USD
Hello good afternoon,
We would like to ask for your assistance in designing an instant heater system using Arduino as its controller
The system should contain the following:
1) The electrical heater element should be ultra low density wattage
2) 4 elements heater (in sequence*)
3) hot water circulation pump control
4) boost pump control
5) 2-3 heat sensors
*Sequence: on/off in sequence to prevent them burning at different times more than one can work depending on the situation.
- Full safety
- boost pump should accelerate instead of going full throttle from the get go
- messages on the phone for any reports or system faults
I would also like to get sources for the used materials
We would like to ask for your assistance in designing an instant heater system using Arduino as its controller
The system should contain the following:
1) The electrical heater element should be ultra low density wattage
2) 4 elements heater (in sequence*)
3) hot water circulation pump control
4) boost pump control
5) 2-3 heat sensors
*Sequence: on/off in sequence to prevent them burning at different times more than one can work depending on the situation.
- Full safety
- boost pump should accelerate instead of going full throttle from the get go
- messages on the phone for any reports or system faults
I would also like to get sources for the used materials