Firmware for P10 display using Mikroe Clicker 2
Budget: $750 – $1,500 USD
I have firmware for 7 segments display written in C, for Arduino. It displays data from the serial RS-485 or the DAC 4-20mA interface, into the 4 digits.
In addition to adapting the Arduino firmware to the PIC18F, two P10 displays will be used to replace the 4-digit, 7-segment display.
P10 display libraries available on the internet (validated).
The hardware:
> Mickroe Clicker 2 for PIC18FK
> RS485 Isolator 2 Click
> 4-20mA R click
> 2un P10 display
In addition to adapting the Arduino firmware to the PIC18F, two P10 displays will be used to replace the 4-digit, 7-segment display.
P10 display libraries available on the internet (validated).
The hardware:
> Mickroe Clicker 2 for PIC18FK
> RS485 Isolator 2 Click
> 4-20mA R click
> 2un P10 display