Arduino IDE support
Budget: $10 – $30 USD
Recently I have been getting error messages in Arduino IDE that prevent me from uploading new sketches to the board. I'm using a generic copy of the Nano, and running the Arduino IDE in Linux Mint.
Looking for an Arduino expert to help guide me to a solution.
This is the message I see when I attempt to upload a sketch:
Sketch uses 7358 bytes (23%) of program storage space. Maximum is 30720 bytes.
Global variables use 1321 bytes (64%) of dynamic memory, leaving 727 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
Looking for an Arduino expert to help guide me to a solution.
This is the message I see when I attempt to upload a sketch:
Sketch uses 7358 bytes (23%) of program storage space. Maximum is 30720 bytes.
Global variables use 1321 bytes (64%) of dynamic memory, leaving 727 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00