Arduino CAN-Bus - I/O Gateway
Budget: €30 – €250 EUR
I need an Arduino Mega programmed, so that it gets data over CAN Bus and then controls a Speedometer based on these CAN Bus informations.
This CAN Shield will be used: https://wiki.seeedstudio.com/CAN-BUS_Shield_V2.0/
Based on the CAN Bus informations, It needs to control the following outputs:
1 speedsignal: 58 time slots with high/log signal, followed by 2 time slots of low/low signal for synchronization (so its like some kind of special function that needs to be generated)
4 analog outputs with voltage 0 - 12 V
12 simple digital outputs
Thats about it.. Open for suggestions and looking forward to get started!
This CAN Shield will be used: https://wiki.seeedstudio.com/CAN-BUS_Shield_V2.0/
Based on the CAN Bus informations, It needs to control the following outputs:
1 speedsignal: 58 time slots with high/log signal, followed by 2 time slots of low/low signal for synchronization (so its like some kind of special function that needs to be generated)
4 analog outputs with voltage 0 - 12 V
12 simple digital outputs
Thats about it.. Open for suggestions and looking forward to get started!