PCB, coding, microcontrollers. some hardware experience may be needed. In certain cases the hardware may have to be done after by another party only after all the requirements have been completed.

I have the entire code for a master slave python daisy chain code configuration

and may need some small refactoring ect..

The two codes are nearly the same except that certain components are removed.

I have done the most to make this job easy as possible.

I have downloaded many of the adafruit libraries into a Ardriuno sketch folder (.cpp, .h).

I have also compared the 2 codes and no errors have been detected so far.

I have the code in both Python and C++.

Some of the code may need the domain names ect., which can be provided as needed.

Other libraries ect., may have to be imported and or changed.

The code may need some debugging, testing.

I do want to keep the comments within the code.

The code may need archetecture.

The code needs to then be put on to the master and slave microcontrollers.

I also have the PCB gerber files ect.

I also need the microcontrollers placed within the PCB and the prototype PCB.

Some of the components are of the same communication protocol and
may require a bus ect., which i have placed within the code.

We may use an alternate to the Ardriuno, and Adafruit.