Recreate Analog Schematic in KiCad
Budget: ₹2,000 – ₹5,000 INR
I have finished the digital side of my board in KiCad and exported the full Gerber set. What I still need is the analog section turned back into a clear, editable KiCad schematic and then merged into my existing project so the whole design can move forward as one file set.
You will start from the Gerber files that show only the analog portion. That portion contains resistors, capacitors, op-amps and a few discrete transistors—no inductors or transformers. Feel free to stick with KiCad’s default reference naming; I am not following a custom scheme. After the first pass I’ll send you the exact descriptive notes and call-outs I want on certain nodes and test points, so please leave room for that commentary.
What I expect back:
• A complete, logically laid-out KiCad schematic for the analog block, ready to annotate and ERC-clean
• Updated project file where this schematic is linked to the existing digital one, with footprints already assigned or matched to the board where possible
• Clean netlist and design-rules check without new errors
I will review the draft, add my notes, and then we can lock down the final version for manufacturing. If you have questions while tracing the Gerbers, just ask; speed and accuracy are both important to me.
You will start from the Gerber files that show only the analog portion. That portion contains resistors, capacitors, op-amps and a few discrete transistors—no inductors or transformers. Feel free to stick with KiCad’s default reference naming; I am not following a custom scheme. After the first pass I’ll send you the exact descriptive notes and call-outs I want on certain nodes and test points, so please leave room for that commentary.
What I expect back:
• A complete, logically laid-out KiCad schematic for the analog block, ready to annotate and ERC-clean
• Updated project file where this schematic is linked to the existing digital one, with footprints already assigned or matched to the board where possible
• Clean netlist and design-rules check without new errors
I will review the draft, add my notes, and then we can lock down the final version for manufacturing. If you have questions while tracing the Gerbers, just ask; speed and accuracy are both important to me.