STM32F469 Disco KIT Equivalent PCB Design

I'm seeking a PCB design in Fusion 360, based on the STM32F469 Disco KIT. The new design should exclude the audio and Arduino components but include two RAST 4-pin connectors - one for I²C2 and another for UART.

Key requirements:
- Use the same MCU, SDRAM, Flash, etc. as the original kit
- Maintain the same Bill of Materials (BOM)
- Design should fit within a standard form factor
- Target application is consumer electronics

Ideal skills and experience:
- Proficiency in Fusion 360
- Prior PCB design experience, particularly for consumer electronics
- Familiarity with STM32F469 Disco KIT
- Experience with I²C and UART connections
- Able to deliver a standard sized PCB design
- Familiar with high-frequency trace design at 166 MHz.