Statue Photogrammetry 3D Model
Budget: $10 – $30 USD
I have a full photo set of a small statue and need those images turned into a precise, print-ready 3D file. You can use Autodesk ReCap Photo or any equivalent photogrammetry software, but the end result must be a single, watertight mesh that captures fine surface detail.
Key points
• Purpose: the piece will be printed in PLA, so overhangs and wall thickness should respect common FDM guidelines.
• Detail level: high—every fold, texture, and subtle contour visible in the reference photos should read clearly once printed.
• Geometry only: no UVs, colours, or textures required.
• Clean-up: remove noise, close holes, decimate intelligently, and be sure normals are consistent so slicers don’t complain.
Deliverables
1. Finished mesh in STL format
2. The same mesh in OBJ format
If you’ve handled photogrammetry captures before—especially statues or figurines—please include one or two examples so I can see the quality of your past work.
Key points
• Purpose: the piece will be printed in PLA, so overhangs and wall thickness should respect common FDM guidelines.
• Detail level: high—every fold, texture, and subtle contour visible in the reference photos should read clearly once printed.
• Geometry only: no UVs, colours, or textures required.
• Clean-up: remove noise, close holes, decimate intelligently, and be sure normals are consistent so slicers don’t complain.
Deliverables
1. Finished mesh in STL format
2. The same mesh in OBJ format
If you’ve handled photogrammetry captures before—especially statues or figurines—please include one or two examples so I can see the quality of your past work.