Finalize Bracket STL for Printing

The bracket model is already about 80 % complete in SolidWorks, but it still has a few open gaps that prevent it from exporting as a clean, watertight file. I need those gaps fully closed and the overall part smoothed so it slices without errors for FDM 3D printing.

You will receive the native SolidWorks file; please work directly in that environment, repair the geometry, refine any rough edges, and then deliver:

• a manifold, error-free STL ready for 3D printing
• the updated SolidWorks file reflecting the fixes

I’ll consider the job done when the STL loads in Cura or prusa without red surfaces and passes a mesh check such as Netfabb, holding original dimensions within ±0.2 mm.