Airbrush Coaching for Miniatures & 3D printed parts
Budget: $25 – $50 USD
I'm looking for an airbrush expert to help me with some advice via Zoom / Google Meets / Discord. I'm using a GHPM-Mobius TG 0.5mm Airbrush with airbrush flow improver, thinner, retarder, and airbrush paints for Gaahleri and Vallejo.
I also have a Harder & Steenbeck 122233 Infinity 2024 CRplus 2-in-1 (0.25 + 0.44 mm) but I mostly use the Mobius.
The problem:
- I'm using black / white primer for large 3D prints like vases and I need to be able to paint for 30-60 minutes without stopping;
- right now I have to stop every 10-15 minutes and completely clean the airbrush: remove the ring, clean the tip, full clean (I don't remove the needle though)
- the clogs are not because of the paint being too thick, it's because the paint accumulates at the tip and it forms clogs. The spray is not longer straight.
- I'm using 20-30 PSI
I need 1-2 hours of help in real time.
I also have a Harder & Steenbeck 122233 Infinity 2024 CRplus 2-in-1 (0.25 + 0.44 mm) but I mostly use the Mobius.
The problem:
- I'm using black / white primer for large 3D prints like vases and I need to be able to paint for 30-60 minutes without stopping;
- right now I have to stop every 10-15 minutes and completely clean the airbrush: remove the ring, clean the tip, full clean (I don't remove the needle though)
- the clogs are not because of the paint being too thick, it's because the paint accumulates at the tip and it forms clogs. The spray is not longer straight.
- I'm using 20-30 PSI
I need 1-2 hours of help in real time.