3D modelling base on diagram
Budget: $30 – $250 USD
I need a 3D model that can be edited and modified with Fusion 360 for 3D printing.
The model should be based on the attached cut-away diagram.
The diagram consists of 8 different parts as follows.
30in conductor housing: Light blue
18 3/4in wellhead housing: Blue
7in casing hanger: Green
9 5/8in casing hanger: Light Green
13 3/8in casing hanger: Turquoise
Temporary Abandonment Cap: Orange
3 x Pack off: Dark Blue (only 1 needed as they are similar)
To produce the 3D models, the diagram can be revolved as all the components are round.
The grey pipe fitted to the bottom of each component with be produced separately with threads and screwed onto the components.
Every part should be produced according to the measurements as they will be 3D printed and assembled afterwards.
The largest component (18 3/4in wellhead housing: Blue) will be 200 mm. The rest will follow according to scale.
The model should be based on the attached cut-away diagram.
The diagram consists of 8 different parts as follows.
30in conductor housing: Light blue
18 3/4in wellhead housing: Blue
7in casing hanger: Green
9 5/8in casing hanger: Light Green
13 3/8in casing hanger: Turquoise
Temporary Abandonment Cap: Orange
3 x Pack off: Dark Blue (only 1 needed as they are similar)
To produce the 3D models, the diagram can be revolved as all the components are round.
The grey pipe fitted to the bottom of each component with be produced separately with threads and screwed onto the components.
Every part should be produced according to the measurements as they will be 3D printed and assembled afterwards.
The largest component (18 3/4in wellhead housing: Blue) will be 200 mm. The rest will follow according to scale.