3D design
Budget: £10 – £20 GBP
I need to create a container to house both the microcontroller (Feather Huzzah) and the TDK sensor listed in the attached table.
The TDK sensor should be placed in a small compartment attached to the base of the container, resembling a separate room. A small hole should be made at the bottom of this sensor compartment for the wires to pass through.
Additionally, a second layer should be designed to fit above the microcontroller. This layer should be flat and have holes on both sides. These holes are meant for the wires connected to the battery, allowing them to exit the enclosure.
It's flexible to adjust the size of the container, ensuring there's ample space around the components inside. The primary objective is to securely accommodate the microcontroller, sensor, and necessary wiring while maintaining their fixed positions within the box.
The design specifics are open-ended, so feel free to use your creativity while ensuring the mentioned components can be securely placed inside the enclosure.
The TDK sensor should be placed in a small compartment attached to the base of the container, resembling a separate room. A small hole should be made at the bottom of this sensor compartment for the wires to pass through.
Additionally, a second layer should be designed to fit above the microcontroller. This layer should be flat and have holes on both sides. These holes are meant for the wires connected to the battery, allowing them to exit the enclosure.
It's flexible to adjust the size of the container, ensuring there's ample space around the components inside. The primary objective is to securely accommodate the microcontroller, sensor, and necessary wiring while maintaining their fixed positions within the box.
The design specifics are open-ended, so feel free to use your creativity while ensuring the mentioned components can be securely placed inside the enclosure.