Troubleshoot 3D STL / OBJ model
Budget: $15 – $25 USD
Hello.
I have created an STL model using ZBrush>Meshmixer. I hollow it to print. The problem I find is thin walls.
I get this problem if I offset the hollow by 1/2/3 or 4mm: Same problem: Lot's of random thin walls. I would like someone to assist in fixing the issue without losing surface detail. It would be great if someone could instruct me on how to avoid these problems too.
Many thanks,
Alex
I have created an STL model using ZBrush>Meshmixer. I hollow it to print. The problem I find is thin walls.
I get this problem if I offset the hollow by 1/2/3 or 4mm: Same problem: Lot's of random thin walls. I would like someone to assist in fixing the issue without losing surface detail. It would be great if someone could instruct me on how to avoid these problems too.
Many thanks,
Alex