Plant 3D Model for 2D Extraction Isometrics
Budget: $1,500 – $3,000 USD
This is not a graphic design work. The intent of the 3D is only to generate the 2D extraction Isometrics with BOM, Pipe support call outs, Piping Layout.
There is no clash check or review of 3D model involved. All the clash check is site verified with mark-ups provided by the construction team. This is the reason for a few iterations needed for the final iso and layout extraction. This will be exercise to merely update the 3D and do an another extraction. I am thinking comparing this with the effort it would have otherwise taken if done on AutoCad.
A proof of concept is needed as a pre-qualification to know whether we understand what is needed and that you are able to do what is asked for. This is a pre-qualification. This should not take more than 1/2 hour on Plant 3D and is not paid. The actual work is to MH estimated and paid by an agreed rate.
1) Please model a sample 3" line using the CS150 Pipe spec from Plant 3D built in pipe class. The route is shown on the .kmz file at the files tab, start and end points and the general route. Use the .kmz as a reference to overlay the 3D route. Route the line with BOP 3 m from grade. Add a few supports in between the approx 6 km run.
2) Extract using the Plant 3D tools, without any manual intervention:
a) Isometrics with MTO.
b) A Layout of the run.
There is no clash check or review of 3D model involved. All the clash check is site verified with mark-ups provided by the construction team. This is the reason for a few iterations needed for the final iso and layout extraction. This will be exercise to merely update the 3D and do an another extraction. I am thinking comparing this with the effort it would have otherwise taken if done on AutoCad.
A proof of concept is needed as a pre-qualification to know whether we understand what is needed and that you are able to do what is asked for. This is a pre-qualification. This should not take more than 1/2 hour on Plant 3D and is not paid. The actual work is to MH estimated and paid by an agreed rate.
1) Please model a sample 3" line using the CS150 Pipe spec from Plant 3D built in pipe class. The route is shown on the .kmz file at the files tab, start and end points and the general route. Use the .kmz as a reference to overlay the 3D route. Route the line with BOP 3 m from grade. Add a few supports in between the approx 6 km run.
2) Extract using the Plant 3D tools, without any manual intervention:
a) Isometrics with MTO.
b) A Layout of the run.