Modify STL file and provide in more easily editable format

Job ID: 31189451

Budget: £10 – £20 GBP

I found an existing design in an STL file (see attached) for a watch-sized plastic case online (see attachment).

But I need some modifications made to the design:

1. The rectangular base made slightly wider, so that the circular section no longer 'protudes' over the sides when looking from the top. Ideally the tip of the circle is exactly in line with the edges of the rectangle (but the circle cannot change dimensions).

2. The addition of two further internal 'steps' on the inside (you can see there is currently one such step).

Imagine the same as the current step added to the opposite side, but this time with a rectangular gap in the middle.

The purpose of the original step is to hold the circuit board opposite the switch (see puck.jpg) up so it is level given the extra height the switch provides on the other side. However this still allows some rotation of the board within the case. The two new steps would sit either side of the switch, preventing rotation.

3. The angled 'holes' at either end of the rectangle (whose purpose is to take a wrist strap) need to be able to accomodate a thicker (not wider) strap (the strap to be used is 25mm, and the current design is wide enough, but the 'slit' is too narrow). It needs to be twice as wide. The rectangular base can be made a little longer to accomodate this.

General -

Ideally the produced output is in a file format which I can easily edit each section with free or cheap software (tinkercad?), rather than just a single STL file, should I want to make minor changes later on.
Related categories: CAD/CAM Product Design 3D Modelling