3D Model for Sliding Square Adjustable Support
Budget: $10 – $30 CAD
I am needing a 3D model made for a set of 2 square tubes that will be used for a sliding adjustment.
The outer tube is is to be 1 inch in width. And have a 3mm hole on one side.
The inner tube is to fit inside the other so that they are snige with just enough room so slide.
The inner tube will have hole rotating around that are 1mm apart from one side to the next. This will allow for 1mm adjustments
The holes must not exceed the portion one third of the inner tube and must be at the one third point of the outer tube.
Both tubes are 2 feet long.
I am most familiar with Blender and Cura, so i would need the file to be an OBJ.
I am only looking to pay $20 for the model
The outer tube is is to be 1 inch in width. And have a 3mm hole on one side.
The inner tube is to fit inside the other so that they are snige with just enough room so slide.
The inner tube will have hole rotating around that are 1mm apart from one side to the next. This will allow for 1mm adjustments
The holes must not exceed the portion one third of the inner tube and must be at the one third point of the outer tube.
Both tubes are 2 feet long.
I am most familiar with Blender and Cura, so i would need the file to be an OBJ.
I am only looking to pay $20 for the model