Mechanical Dragon Head with Steam Vent (3D Printing Optimized)
Budget: €8 – €30 EUR
I'm looking for an experienced 3D designer who can model a mechanical dragon head for me based on an existing template. The model will serve as an outlet for a humidifier and therefore needs to meet some specific requirements.
Design Specifications:
The design should closely follow the ArtStation template shown. But it can be also look more like a dragon (not like a shark). My Intention is, that i have some nett technic stuff in my growtent and wanted print a stylisch humidifier outlet.
https://www.artstation.com/artwork/wJWJV9
I pay particular attention to:
- The characteristic mechanical aesthetics of the original design
- A symmetrical finish without damage or weathering
- A smooth metallic appearance with subtle panel lines approximately 1 mm deep
- A wide-open mouth (at least 15 mm opening height)
Technical specifications:
For the steam vent function, I need:
- A straight, smooth passage with a 25 mm diameter running from the back of the head to the mouth opening
- A continuous wall thickness of exactly 2.5 mm (±0.1 mm tolerance)
- Enable support-free printing (maximum 45° overhangs)
- Compatibility with standard print settings (0.2 mm layer height)
- Four M4 threaded holes (6 mm deep) on the base for mounting
Printing requirements:
The model should be easily printable with common FDM printers and materials (PLA/PETG). Special emphasis is placed on:
- A waterproof, print-ready STL
Best regards Christian
Design Specifications:
The design should closely follow the ArtStation template shown. But it can be also look more like a dragon (not like a shark). My Intention is, that i have some nett technic stuff in my growtent and wanted print a stylisch humidifier outlet.
https://www.artstation.com/artwork/wJWJV9
I pay particular attention to:
- The characteristic mechanical aesthetics of the original design
- A symmetrical finish without damage or weathering
- A smooth metallic appearance with subtle panel lines approximately 1 mm deep
- A wide-open mouth (at least 15 mm opening height)
Technical specifications:
For the steam vent function, I need:
- A straight, smooth passage with a 25 mm diameter running from the back of the head to the mouth opening
- A continuous wall thickness of exactly 2.5 mm (±0.1 mm tolerance)
- Enable support-free printing (maximum 45° overhangs)
- Compatibility with standard print settings (0.2 mm layer height)
- Four M4 threaded holes (6 mm deep) on the base for mounting
Printing requirements:
The model should be easily printable with common FDM printers and materials (PLA/PETG). Special emphasis is placed on:
- A waterproof, print-ready STL
Best regards Christian