Manx Faerie Ingots

Job ID: 31150147

Budget: $50 – $0 USD

Size: 1 x 2 x 0.25 inches



3 ingots, double-sided (obverse/reverse) like a coin.



Each side will have the exact same pattern with Celtic border (raised) and a central 'coin' of the Manx (Isle of Man) emblem (also raised but contoured as a coin. The USA copper ingots on the schema are examples of the look).



Two of the reverse sides also feature elongated footprints. One design has a single footprint, the other has the exact same footprint plus two others. These footprints are to look (as much as possible) like footprints in the sand, pressed into the surface of the ingot and modelled from deep at the heel and toes to swallow at the arch with perhaps a slight rise/bulge around the deepest areas (if possible) to suggest where the 'sand' has been squeezed upwards from displacement. Again, this should be subtle, but I understand that you must work within the capabilities and parameters of the program and printer. These footprints are to suggest believably that a little person (a fairy) has walked across the copper and dented it as if it were sand on a beach: a better footprint image may be substituted at your discretion to achieve this look.