Make a 3D printable model of this.
Budget: £10 – £20 GBP
it should have a screw thread on each half to tighten closed (like a bottle cap). it should be approx 95mm wide by 35mm high when closed. it's for storing tobacco.
There should be a design feature where there is an o-ring to create a water tight seal.
it should be a STL file.
Color is not necessary, but relief if (please make it hatched or interlocking circles for grip, or something modern)
if supports on file included then it's a bonus.
I will own the file for any use that I wish.
There should be a design feature where there is an o-ring to create a water tight seal.
it should be a STL file.
Color is not necessary, but relief if (please make it hatched or interlocking circles for grip, or something modern)
if supports on file included then it's a bonus.
I will own the file for any use that I wish.