Hydroponic Tower 3d Printable Design
Budget: $30 – $250 USD
I need to create a hydroponic grow tower. This will consist of 4 modular parts.
1) Cap - 4" cap for the top of the tower
2) Distribution Module- Will be able to connect a 1/2" id tube to the bottom of this piece so that water will shoot out of the top of it.
3) Base- Will screw on to the bottom so that it may sit on the top of a bucket.
4) Plant Holders- this is the main module, it will be 4" in diameter and 1/10" thick. It will have 3x 2 1/10" holes to sit plant pots in. It will have a flat bottom with holes in it so that water rains down below it. It will have a 1" hole in the middle so that the 1/2" tube may run up the center and overflow water may fall down.
All pieces will be modular and able to screw into each other.
1) Cap - 4" cap for the top of the tower
2) Distribution Module- Will be able to connect a 1/2" id tube to the bottom of this piece so that water will shoot out of the top of it.
3) Base- Will screw on to the bottom so that it may sit on the top of a bucket.
4) Plant Holders- this is the main module, it will be 4" in diameter and 1/10" thick. It will have 3x 2 1/10" holes to sit plant pots in. It will have a flat bottom with holes in it so that water rains down below it. It will have a 1" hole in the middle so that the 1/2" tube may run up the center and overflow water may fall down.
All pieces will be modular and able to screw into each other.