Hollow Three Sculpture OBJ Models
Budget: $15 – $25 USD
I have three finished sculpture files in .obj format that I want to lighten before printing. Your job is to open each model, generate an even shell roughly 3 mm–4 mm thick, and return the cleaned, watertight OBJs ready for slicing. These pieces are strictly decorative, so you can hollow the entire volume—no zones need to stay solid and I do not want any internal lattices or support meshes.
Please keep all exterior surface detail intact, remove any non-manifold artefacts that appear during the shell operation, and make sure the final wall thickness falls inside the stated range when checked in Cura or similar. Work in Blender, ZBrush, Meshmixer, MeshLab or whichever tool you prefer as long as the exported geometry passes a quick printability check on my end.
I’d like the revised files back within a day or two. Once I confirm the shells sit between about 2.8 mm and 4.2 mm throughout and slice without errors, the project is complete.
Please keep all exterior surface detail intact, remove any non-manifold artefacts that appear during the shell operation, and make sure the final wall thickness falls inside the stated range when checked in Cura or similar. Work in Blender, ZBrush, Meshmixer, MeshLab or whichever tool you prefer as long as the exported geometry passes a quick printability check on my end.
I’d like the revised files back within a day or two. Once I confirm the shells sit between about 2.8 mm and 4.2 mm throughout and slice without errors, the project is complete.