Fix SolidWorks Dimension Lag

When I type a dimension in a 2-D sketch the entire interface freezes for several seconds before updating, and that stop-start rhythm is crippling my workflow. I spend most of my day inside SolidWorks part files under 10 MB, so there is no reason these simple sketches should feel like I am working on a huge assembly.

I would like you to look at every likely culprit—system options, graphics drivers, templates, add-ins, even Windows settings—and show me exactly where the bottleneck sits. A short screen-share session to watch the issue live, followed by a SolidWorks RX report and a clear action plan, should be enough for you to pin it down.

Deliverables
• Written diagnosis that identifies the root cause(s) of the lag.
• Step-by-step fixes or settings tweaks I can apply immediately.
• A brief checklist to keep future part files running smoothly.

Once your recommendations are in place I will test them on three of my typical models; if dimension entry is instant (or close to it) the job is complete.