DXF Laser-Cut Part Drawings

I have two very simple profiles that must be translated into clean DXF files ready for laser cutting and I need them back within half a day.

Part 1 is a round flange that contains a single oval hole plus two round holes.
Part 2 is a rectangular plate that carries four ovals and eight round holes.

All dimensions will be supplied in millimetres and will specify:
• the exact length and width of every oval slot
• the diameter and XY-position of each round hole

Deliverables
• Two separate 2D DXF files, one for each part, laid out full-scale at 1 : 1
• Geometry organised on sensible layers so the laser vendor can identify cut paths immediately
• No redundant lines, overlaps or open contours—everything must pass a quick “closed-profile” check in AutoCAD or similar

Once I receive the DXFs I will run them through my nesting software; if they load cleanly and dimensions match the values I provide, the job is done and paid.